Strong N52 magnet — holds 5+ lbsScrews, bits, hardware — all within reach

Tech safe & phone friendlyWon't damage your phone or cards

Features & Benefits

Stop Setting Tools Down

Grab It Without Looking — magnetic tool holder built for real work

N52 Neodymium Magnet Core — Holds over 5 lbs without slipping, so a handful of screws, a driver bit swap, or a framing hammer stays put on your hip until you need it. No setting tools down, no fishing around in your pocket mid-task. Electricians use it to hold screws while wiring overhead. HVAC techs clip on their snips before heading up the ladder. Plumbers run it on their overalls so their cutters are always within reach.

Clips to Any Belt, Harness, or Bag Strap — belt clip magnet that goes where you go

Modular clip system — Clips onto your existing belt, tool pouch, bag strap, or safety harness. Attach it, move it, take it off in seconds with one hand. Roofers clip it to their harness. Solar installers move it between their vest and ladder rail depending on where they're working. One magnet, configured however the job demands.

Tether Your Tools When It Counts — extra safety for work at height

Built-in lanyard loop — Working on a roof, up a pole, or out of a bucket truck means a dropped tool is more than an inconvenience. The lanyard loop lets you tether tools to your harness so nothing falls to the crew below. Linemen, roofers, and solar installers working from heights use it as a standard part of their setup.

Lifetime Guarantee and Assembled in USA

Lifetime repair or replace guarantee — If it breaks, we fix it or replace it. No questions asked, no time limit. The MagMaster is assembled in the USA from ultra-durable thermoplastic — phone-safe, card-safe, and built to take a full day on the job site every day. Customers who've had theirs since 2021 are still running them. When they do finally come back, it's to buy a second one.